Fudge 102 – newb’s guide to getting started (2024)

In Fudge 101wecovered a brief introduction of what is fudge, the ingredients of fudge, and the technique of making fudge. Fudge 102 is aimed at the newbie who is going to try their hand at making fudge. Now it’s getting exciting.

How long does it take to make fudge:

  • about 18 min to reach boiling
  • about 40 minutes to reach soft ball stage
  • 60 minutes to cool
  • 28 minutes to beat in a KitchenAid (your time for this may vary)
  • 4 hours to set

Tips for the fudge newb:

Check the weather. If it’s humid don’t make fudge today.

You don’tneeda candy thermometer, but the ball stage is difficult for a newb to judge correctly, and the window of time between under-cooked and over-cooked is razor-thin. Save yourself the tears and get a good, digital candy thermometer. I havethis Taylor thermometerwhich is available onAmazon.comfor $22., I picked mine up at the St. Lawrence Market and also use it for tempering chocolate.

Get everything ready before you turn on the stove. Line your pan with foil and grease it. Completely grease the pot you’ll cook the sugar in, right up to the edge. Grease the wooden spoon or beater blade.

Have a jug of cold water in the fridge, and a larger pan set on the counter to be the water bath.

Read your recipe thoroughly, make sure you understand when to stir and when not to. Understand at what point you add any extras like nuts or fruit (typically right before it’s ready to be poured into the pan).

Beware the recipe that tells you to chill the fudge to ensure it sets. Proper fudge will set after sitting at room temperature for about 4 hours.

Understand that cooking the fudge properly is the skirmish before the war. The real test of your mettle will occur when you beat the fudge, and learn to master the fine art of turning and pouring. And if it doesn’t work out it’s okay! Don’t give up.

What works for one person…

  • some recipes insist on cream, others use milk
  • some add the butter at the beginning, others add it when the vanilla is added
  • some people use a wet pastry brush to wipe away sugar crystals
  • some people only beat by hand, others use a hand mixer or stand mixer

Personally, I use 2% milk, becauseevery timeI made fudge with cream it failed. I add the butter at the beginning, and beat it using my KitchenAid. My fudge never turned out until I started using a water bath, and I am still mastering when to stop beating it.

Equipment:

  • digital candy thermometer, remember to calibrate it
  • heavy-bottom sauce pot, ideally with straight sides so you can clip thermometer onto it
  • sturdy wooden spoons (avoid metal which conducts the insane heat right into your skin)
  • hand mixer or stand mixer (unless you’re a masoch*st and you actually want to beat fudge by hand, in which case have at it)
  • 8″ square pan + one bigger pan to serve asthe cold water bath
  • tin foil

OK! I’m ready to get fudging!

Just one more thing! I talked earlier about when the thermometer hits “soft ball” (235°F to 240°F, or 112.78°C to 115.55°C) you should remove the pot from the heat immediately and place it in a cold water bath.

Not all fudge-makers use a cold bath, but I recommend it for this reason: supersaturated sugar is so hot, it continues to cook after you remove it from the heat (like taking something out of the microwave, it keeps getting hotter). If you are removing the fudge from the stove at the top of the soft ball range, which is no higher than240°F or 116°C , your fudge willcook itselfright past the optimum temperature and no wonder it’s not going to set.

Once it starts creeping up to the ideal range, I watch it like a hawk, and as soon as it’saboutto hit soft ball (it’s one or two tenths of a degree away), I take it off the stove and set it in the water bath pan. As soon as the temperature peaks I add the cold water so that way it can’t get past soft ball. Thetemperature will begin to drop and now you can’t exceed the soft ball stage. Make sense?

Let the pot sit undisturbed between 30-60 minutes, until temperature drops to 100°F or 37.77°C. Some people say you don’t need to go this low, but I’ve started aiming for this temperature after reading how cooler sugar crystals stay smaller (to avoid grainy fudge).

Then, andonly then, are you ready for the final confrontation.

Fudge 102 – newb’s guide to getting started (2024)

FAQs

How long do you let fudge cool before beating? ›

Let cool before beating

After being cooked, the sugar must crystallize again to create fudge. This stage will determine the size of the sugar crystals. The sugar should ideally form small crystals that are barely discernible on the tongue. To achieve this, let the mixture cool for 15 minutes before beating it.

What is the secret to good fudge? ›

The trick to good homemade fudge is to cook the ingredients to the right temperature to form a sugar syrup, and cool the mixture properly so the texture of the fudge turns out smooth and firm, but soft enough to cut.

Why is my 3 ingredient fudge not setting? ›

Why won't my 3 ingredient fudge set? This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool.

How to know when fudge is ready to set? ›

You know it's ready when a small amount of the mixture dropped into a glass of cold water sets into a soft ball that you can lift out with a teaspoon and pinch between your fingers. Turn off the heat and keep stirring for 5 minutes or until the mix starts to thicken a little.

What happens if you beat fudge too early? ›

Beating before cooling

This fudge was beaten immediately after cooking, while it was still very hot. Its crystals are so big that it has practically reverted back to a sugar state!

Do you stir fudge when it's boiling? ›

Avoid Stirring Once the Mixture Comes to a Simmer

Another key part of a successful fudge texture is when you stir the mixture. Stirring the sugar and milk during the initial stages of cooking allows the sugar to dissolve. However, once the mixture comes to a boil, it's time to put the spoon down.

Can you reboil fudge that hasn't set? ›

How can you fix soft fudge? Put it in a microwave safe bowl that is large enough that it won't boil over. Reheat it to the boiling point and cook for about 3 more minutes. Then you can beat some powdered sugar into it if this doesn't make it set.

What is the best pan to make fudge in? ›

Opt for a pot that can contain approximately four times the total volume of your fudge ingredients. Secondly, the pot's material should allow for good heat distribution hence your top choice should be copper cookware or a pot with a copper core.

What is the secret to smooth fudge that is not gritty? ›

Once the sugar has dissolved and the mixture has come to a boil, do not stir it. If you do, the sugar can crystallize, giving your fudge a gritty texture. As you beat the fudge, pay attention to color and texture. Once the fudge loses its sheen and thickens, put down your spoon.

What can I do with failed fudge? ›

Options for what you can do with your unset fudge:

OPTION 1) Depending on how runny it is, you can either use it as a frosting for cakes, or a sauce for ice-cream. OPTION 2) Freeze it overnight. Cut it into squares. Cover each square thickly in melted chocolate, ensuring no part of the fudge is exposed.

Why is fudge so hard to make? ›

Making fudge can be a challenging endeavor, requiring precision and attention to detail to achieve the perfect texture and consistency. The process of making fudge involves a delicate balance of cooking, cooling, and beating, and the smallest mistake can result in fudge that is too soft or too hard.

How do you cut fudge so it doesn't crumble? ›

If you have difficulty cutting or if the fudge crumbles with the cuts, try warming the metal knife (or wheel or whatever) in hot water between cuts. Wipe the hot knife dry before cutting. Whatever you use, always wipe the cutting implement clean between cuts.

Can you overmix fudge? ›

Rock Hard Fudge

Beating the cooled batter is one of the crucial steps of fudge-making, but overbeating can turn fudge hard as a rock.

What is the soft ball test for fudge? ›

The cold-water test for soft ball stage is this: Fill a cup with very cold water. Spoon a small amount of the boiling candy mixture into the cold water. If the syrup forms a soft ball in the water that flattens when removed, it is at soft-ball stage.

Why did my fudge turn into toffee? ›

If your fudge has a texture like soft toffee, it could be due to overcooking, using too much sugar or butter, or not cooking it to the right temperature.

Can you overbeat fudge? ›

Beating the cooled batter is one of the crucial steps of fudge-making, but overbeating can turn fudge hard as a rock. Pay close attention to the change in appearance and only beat the fudge until it loses its glossy sheen.

Why shouldn't you stir fudge after it reaches the correct temperature? ›

Without stirring or agitating the pot, allow the fudge to cool to 130°F (54°C)—or even lower! Harold McGee says that “candy texture is affected by the syrup temperature at which crystallization begins,” and this is the temperature where the seeds can form correctly.

How do I get my fudge to harden? ›

Chewy fudge is often the result of undercooking. To fix it, you can reheat the fudge mixture over low heat and continue cooking until it reaches the proper temperature.

Top Articles
Latest Posts
Article information

Author: Rueben Jacobs

Last Updated:

Views: 6051

Rating: 4.7 / 5 (77 voted)

Reviews: 92% of readers found this page helpful

Author information

Name: Rueben Jacobs

Birthday: 1999-03-14

Address: 951 Caterina Walk, Schambergerside, CA 67667-0896

Phone: +6881806848632

Job: Internal Education Planner

Hobby: Candle making, Cabaret, Poi, Gambling, Rock climbing, Wood carving, Computer programming

Introduction: My name is Rueben Jacobs, I am a cooperative, beautiful, kind, comfortable, glamorous, open, magnificent person who loves writing and wants to share my knowledge and understanding with you.